Relays and switches - Sort by: Code (ascending) - active, Code (descending), Price (lowest first), Price (highest first)

Workshop consumables

Relays and switches

Ignition only Voltage stabiliser

Ignition only Voltage stabiliser
Plug and play ignition only voltage stabiliser on ISO power cable for use with aftermarket car radios 



Stock code: 10-602
Price: £24.90

Start stop Voltage stabiliser

Start stop Voltage stabiliser
Plug and play voltage stabiliser on ISO power cable for use with aftermarket car radios on "start stop" cars
for cars that have  both ignition and permanent feeds drop off during engine crank


Stock code: 10-603
Price: £64.99

Start Stop Voltage stabiliser

Start Stop Voltage stabiliser
Start Stop Voltage booster.
This interface stabilises the power supply to an aftermarket head unit that is installed into a car with start stop technology.
Covers both Permanent 12v and switched 12v.

Provided with bullet terminals for custom installtions.
Stock code: 10-604
Price: £89.99

Tyco 12 Volt 30 Amp relay

Tyco 12 Volt 30 Amp relay
Tyco 12 Volt 30 Amp automotive 5 pin relay
Stock code: 10-605
Price: £7.99

Single wire ignition cut relay

Single wire ignition cut relay
This is a normally closed relay wired into a single red wire.
When an earth is supplied to the yellow wire the relay will open and break the contact to open the circuit wire.
Often used to cut the ignition or 12V feed to a device.
Stock code: 10-620
Price: £4.99

Speaker cut relay

Speaker cut relay
This relay can be used to cut audio to one speaker by cutting both positive and negative signals, or two speakers by cutting just the positive signals on two speakers.

The relay is activated by a mute signal (ground), the relay then cuts the speaker feeds.

Stock code: 10-625
Price: £12.99

Speaker divert relay

Speaker divert relay
This relay can be used to cut audio to one speaker to allow a different audio source to play to that speaker.

The relay is activated by a mute signal (ground), the relay then cuts the speaker feed and diverts audio from a different device to the speaker.

This can be used to hard wire handsfree kits that do not have their original mute relays.

Stock code: 10-630
Price: £12.99

Reverse camera power feed relay

Reverse camera power feed relay
10-641 is a power relay to be used when installing a camera into a vehicle.
Sometimes a reverse power feed from a reverse light may not be strong enough to power a camera or may create interference.
This relay can use a weak reverse trigger to switch on a better 12v power feed for a camera.
Stock code: 10-641
Price: £12.99

24v to 12v converter

24v to 12v converter
24volt to 12 Volt converter wired with iso power connector.
Suitable for car audio and handsfree equipment

Stock code: 10-670
Price: £39.50

12V to 6V voltage converter for reverse cameras

12V to 6V voltage converter for reverse cameras
Converts 12V DC to 6V DC to provide a suitable power supply to a parking camera.

Stock code: 10-671
Price: £29.99

Speaker Low voltage trigger module

Speaker Low voltage trigger module
Speaker level amp turn on trigger. Used to turn on remote amplifiers.
Has 1 second delay to prevent turn on pops. Supplies 2amp of current so can turn on multiple amps or power antenna.
Stock code: 23-004
Price: £14.99

2 channel line out converter 80W w/ remote trigger

2 channel line out converter 80W w/ remote trigger
Adjustable 2 channel line output converter with built in amplifier remote trigger.
Converts 2 channels of speaker level audio to 2 channels of line level audio.

Stock code: 23-005
Price: £19.99

2 channel line out converter 150W w/remote trigger

2 channel line out converter 150W w/remote trigger
Adjustable 2 channel line output converter with built in amplifier remote trigger.
Converts 2 channels of speaker level audio to 2 channels of line level audio.

Stock code: 23-006
Price: £24.99

Two-way audio switching interface

Two-way audio switching interface
Allows switching between two audio sources by either a positive or negative trigger.
Stock code: 23-016
Price: £44.99

Video Front and Rear switch box

Video Front and Rear switch box
Video switch box to switch between front and rear camera's or DVD player

includes power cable  &  switch 


Stock code: 27-515
Price: £34.90

Laserline EPS parking system SWITCH

Laserline EPS parking system SWITCH
Optional  push switch for Laserline EPS parking sensors EPS 4009F or EPS8009

Stock code: LAS-EPS09SWITCH
Price: £29.50

Laserline EPS parking system SWITCH

Laserline EPS parking system SWITCH
Optional  push switch for Laserline EPS parking sensors.

Stock code: LAS-EPS-SWITCH
Price: £29.50

Flashpoint parking system SWITCH

Flashpoint parking system SWITCH
Optional LED push switch for Flashpoint parking sensors.
12mm hole size
Stock code: LAS-FPS-SWITCH
Price: £29.50