Speaker fitting accessories - Sort by: Code (ascending) - active, Code (descending), Price (lowest first), Price (highest first)

Speakers and fittings

Speaker fitting accessories

Speaker cut relay

Speaker cut relay
This relay can be used to cut audio to one speaker by cutting both positive and negative signals, or two speakers by cutting just the positive signals on two speakers.

The relay is activated by a mute signal (ground), the relay then cuts the speaker feeds.

Stock code: 10-625
Price: £12.99

Speaker divert relay

Speaker divert relay
This relay can be used to cut audio to one speaker to allow a different audio source to play to that speaker.

The relay is activated by a mute signal (ground), the relay then cuts the speaker feed and diverts audio from a different device to the speaker.

This can be used to hard wire handsfree kits that do not have their original mute relays.

Stock code: 10-630
Price: £12.99

ISO to ISO amplifier integration interface

ISO to ISO amplifier integration interface
4 channel adjustable ISO to ISO amplifier interface.

Use to install a new radio in a car that has an original fit amplifier that takes a pre amplified audio feed.

This interface converts the high level audio output of a new head unit to a low level pre amplified signal which will work with an amplifier.
4 adjustable channels for optimum audio quality, it has a built in ground loop isolator and filters to get the best sound from the amplifier.

Stock code: 20-273
Price: £34.99

Speaker Low voltage trigger module

Speaker Low voltage trigger module
Speaker level amp turn on trigger. Used to turn on remote amplifiers.
Has 1 second delay to prevent turn on pops. Supplies 2amp of current so can turn on multiple amps or power antenna.
Stock code: 23-004
Price: £14.99

Two-way audio switching interface

Two-way audio switching interface
Allows switching between two audio sources by either a positive or negative trigger.
Stock code: 23-016
Price: £44.99

Bass Blocker for 6"x 9" speaker

Bass Blocker for 6"x 9" speaker
Set of two bass blockers (0-300hz) 4ohm
Protects 6" x 9" speakers from damage by eliminating low end frequencies. Improves the performance and power handling of tweeters and midrange .
Stock code: 23-050
Price: £12.99

Bass Blocker for 165mm speaker

Bass Blocker for 165mm speaker
Set of two bass blockers (0-600hz) 4ohm
Protects 6" (165mm) speakers from damage by eliminating low end frequencies. Improves the performance and power handling of tweeters and midrange .
Stock code: 23-051
Price: £12.99

Bass Blocker for 130mm speaker

Bass Blocker for 130mm speaker
Set of two bass blockers (0-800hz) 4ohm
Protects 5&1/4" (130mm) speakers from damage by eliminating low end frequencies. Improves the performance and power handling of tweeters and midrange .
Stock code: 23-052
Price: £12.99

Bass Blocker for 100mm speaker

Bass Blocker for 100mm speaker
Set of two bass blockers (0-1.2Khz) 4ohm
Protects 4" (100mm) speakers from damage by eliminating low end frequencies. Improves the performance and power handling of tweeters and midrange .
Stock code: 23-053
Price: £12.99

Bass Blocker for 80mm speaker

Bass Blocker for 80mm speaker
Set of two bass blockers (0-2.8Khz) 4ohm
Protects 3" (80mm) speakers from damage by eliminating low end frequencies. Improves the performance and power handling of tweeters and midrange .
Stock code: 23-054
Price: £12.99

Bass Blocker for tweeters

Bass Blocker for tweeters
Set of two bass blockers (0-5.6Khz) 4ohm
Protects tweeters from damage by eliminating low end frequencies. Improves the performance and power handling.
Stock code: 23-055
Price: £12.99

Universal ground loop isolator noise filter

Universal ground loop isolator noise filter
Eliminates ground loop noise between the audio source and radio. Stops alternator "whine" and ignition "ticking".
Universal unit works with phono plugs or 3.5 mm audio plug.
Stock code: 24-020
Price: £21.99

Male ISO power and speaker to bare wire

Male ISO power and speaker to bare wire
Male power and speaker connectors to bare wire.
Commonly used to repair an original wiring harness in a car.
Stock code: 30-100
Price: £6.99

Male ISO power and speaker to bullet wires

Male ISO power and speaker to bullet wires
Male power and speaker connectors to wires with bullet terminals.
Commonly used to repair an original wiring harness in a car.
Stock code: 30-101
Price: £6.99

PVC electrical insulation tape

PVC electrical insulation tape
Black 20m x 20mm Insulation tape.
Flame Retardent   BS EN60454
Thickness 0.12mm
Stock code: 80-001
Price: £1.49

Tesa Fleece cloth harness tape

Tesa Fleece cloth  harness tape
For interior use. Hand tearable
Black 25m x 20mm .
Rubber based adhesive
Noise damping, Abrasion resistant
top quality as  used by car manufacturers

Stock code: 80-006
Price: £6.90

Cable Ties (100mm x 2.5mm)

Cable Ties (100mm x 2.5mm)
For various uses.
Black 100 pcs
100mm long x 2.5mm wide

Stock code: 80-120
Price: £1.99

Cable Ties (200mm x 2.5mm)

Cable Ties (200mm x 2.5mm)
For various uses.
Black 100 pcs
200mm long x 2.5mm wide

Stock code: 80-122
Price: £2.99

Cable Ties (300mm x 4.8mm)

Cable Ties (300mm x 4.8mm)
For various uses.
Black 100 pcs
300mm long x 4.8mm wide


Stock code: 80-124
Price: £4.90

Speaker cable 2 x 24/02 (100m)

Speaker cable 2 x 24/02  (100m)
100m roll of Automotive spec speaker cable.
2 x 24/02 copper Figure 8 speaker cable
Black , Black Red

Stock code: 80-C22402
Price: £39.50

Blue spade push-on 4.8mm

Blue spade push-on 4.8mm
Blue Insulated crimp terminal
for wire size 1.5-2.5mm2 (AWG 16 -14)
100 pcs pack 



Stock code: 82-BS5
Price: £5.69

Red Spade push-on 2.8mm for 0.5mm tab width

Red Spade push-on 2.8mm for 0.5mm tab width
Red Insulated crimp terminal
for wire size 0.5-1.5mm2 (AWG 20 -16)
100 pcs pack 

Use on speakers with 0.5mm tab thickness



Stock code: 82-RS3-5
Price: £5.49

Red Spade push-on 2.8mm for 0.8mm tab width

Red Spade push-on 2.8mm for 0.8mm tab width
Red Insulated crimp terminal
for wire size 0.5-1.5mm2 (AWG 20 -16)
100 pcs pack 

Use on speakers with 0.8mm tab thickness



Stock code: 82-RS3-8
Price: £5.49

Red Spade push-on 4.8mm for 0.5mm tab width

Red Spade push-on 4.8mm for 0.5mm tab width
Red Insulated crimp terminal
for wire size 0.5-1.5mm2 (AWG 20 -16)
100 pcs pack 

Use on speakers with 0.5mm tab thickness



Stock code: 82-RS5-5
Price: £5.49

Red Spade push-on 4.8mm for 0.8mm tab width

Red Spade push-on 4.8mm for 0.8mm tab width
Red Insulated crimp terminal
for wire size 0.5-1.5mm2 (AWG 20 -16)
100 pcs pack 

Use on speakers with 0.8mm tab thickness



Stock code: 82-RS5-8
Price: £5.49

Panel tool

Panel tool
Panel tool to help remove dashboard trim panels.
Flat end and forked end.
Bright orange design makes it easy to find when working in a car.

Stock code: 85-207
Price: £12.99