InCarTec Products
Volkswagen Crafter 2017> stereo fitting kit with CAN ignition and service cable

Hover over image to zoom

Volkswagen Crafter 2017> stereo fitting kit with CAN ignition and service cable


Suits Single Din Chassis head-units only, this stereo upgrade kit is to install an aftermarket radio in a 2017 onward Volkswagen Crafter.

This head unit fitting kit includes:
-Radio fascia adapter panel (50-999)
-Antenna adapter cable (21-123)
-Radio replacement cable (20-190-IGN)
-CANbus ignition interface (part of 20-190-IGN)
-Original radio service cable (part of 20-190-IGN)

Complete fitting kit to install an aftermarket radio upgrade in a 2017 onward Volkswagen Crafter. This kit is only for vehicles with the original basic radio.

The fitting kit includes a car radio fascia adapter panel to allow the fitting of an aftermarket car radio upgrade. The fascia adaptor allows the fitting of an aftermarket radio into the dashboard by matching the shape, style and colour of the original radio.
This fascia is supplied with side fixing brackets so a radio can be installed without the need for a fitting cage. The fascia can also be used with a 103mm fitting cage.

A radio replacement adapter cable is included too. The adapter cable allows the fitting of an aftermarket stereo upgrade by adapting the original 52 pin quadlock connector in the vehicle to standard aftermarket ISO connectors.
The built in CANbus interface makes installation plug and play and also provides an ignition power supply to the new radio, this saves needing to find an ignition power supply from the fusebox. The CANbus interface will also give an additional output of your choice, either illumination, handbrake, speed pulse or reverse gear.
The cable has an extension to allow the original radio to be reconnected in order to change the some of the vehicle settings such as time and date and VSC on/off.
Fitting instructions are supplied with the adapter cable.

An antenna adapter cable is in the fitting kit, this cable converts the original antenna connector in the car, known as a Fakra connector, to a standard aftermarket antenna connector, known as a DIN connector.
The adapter cable has a built in module which provides a phantom power feed to the original antenna in the car. A phantom power feed is a 12v power supply that is sent up the centre wire of the antenna cable, this powers the amplifier built into the original antenna. The antenna adapter cable has a loose wire which needs to be connected to the 12v antenna power output of the new aftermarket stereo.


Behind the original radio there is only space for a single din body radio, the lower section behind the radio has the ducts for the air vents. Careful attention needs to be payed to the radio that is to be fitted and the modifications that may be required, either to the fascia kit or the vehicle. We strongly recommend the installation is done by an experienced car audio technician only.

See the image below that shows the available space behind the original radio.

This kit is only for vehicles with the original basic radio. Not suitable for vehicles with original touchscreen radios.

Brand: (Not selected)

Car models: The years stated refer to the model's years of manufacture, please check the item description for information about any changes there may be within these productions years.
Volkswagen - Crafter (2017 >)

Browse our products by category

New products and special offers
Amplifiers and fitting
Antennas, Aerials and Adapters
Audio, Aux, iPod, USB cables and adapters
BLAM Audio - Speakers and Amplifiers
Bluetooth kits and fitting
CANbus interfaces
Car Cameras - Reversing & Rear-view Cameras and Monitors
Car Radio / Stereo Fitting Parts
Car Radio Spares
Car Radios - Aftermarket Head-units
Multimedia & Camera Input and Retention Interfaces
Original Fitting Parts
Parking sensors
Phone Holders and Mounting Brackets
Speaker Fitting Parts and Accessories
Speakers and Subwoofers
Workshop consumables